LG PQRCUCS0C Owners Manual - Page 12

Necessary function before using ESP Function E.S.P function is setting the volume of each fan speed. It is for the convenience of installation. It is recommended that you should not use this function while using the remote controller. 1 Press the mode button and the temperature increasing button L same time for three seconds. PQRCUCS0C Defrost Preheat Out door Room Temp Total on Central Run MODE TEMP FAN SPEED TEMP 2 Set the volume of each fan speed(Low, Medium, Hi) by using the temperature control button. Press the fan speed button to select the fan speed. The value of E.S.P can be adjusted from 1 to 255. 3 If you press the On/Off button while setting the ESP function, it will be canceled. (The picture on the left side is the example of setting the Hi wind to ESP 10.) 4 Press the mode button and the temperature increasing button (L) same time for three seconds. Then the ESP setting will be activated after the temperature display flashes three times. EX) Lo Med 200 100 Setting the Low wind to 210 Setting the Medium wind to 175 * The E.S.P value is set at the proper value at the factory. So it is highly recommended that you should not change the E.S.P value at your discretion. 12 Simple Wired Remote Controller