LG REG-123A Service Manual - Page 18

Disassembly 9. Capacitor 1. Remove the control box. (Refer to section 3) 2. Remove the knobs and the screw that fasten control panel from control box. 3. Remove the screw that located in the front. 4. Open the bottom side of control box. 5. Remove the screw and the clamp that fastens the capacitor. 6. Disconnect all the leads of capacitor terminals. 7. Re-install the components by referring to the removal procedure, above. (See Figure 24) 10. Power Cord 1. Remove the control box. (Refer to section 3) 2. Open the control box. (Refer to section 9) 3. Disconnect the grounding screw from the control box. 4. Disconnect the 2 receptacles. 5. Remove a screw which fastens the clip cord. (See Figure 25) 6. Remove the power cord. 7. Re-install the component by referring to the above removal procedure, above. (Use only one ground-marked hole for ground connection.) 8. If the supply cord of this appliance is damaged, it must be replaced by the special cord. (The special cord means the cord that has the same specification marked on the supply cord attached at the unit.) 11. Thermistor 1. Remove the control box. (Refer to section 3) 2. Open the control box. (Refer to section 6) 3. Disconnet the thermistor terminals from main P.W.B assembly. 4. Remove the thermistor. 5. Re-install the components by refereing to the above removal procedure. (See Figure 26) 12. SYNCHRONOUS MOTOR 1. Remove the control box. (Refer to section 3) 2. Unfold the control box. (Refer to section 10) 3. Remove the crankshaft. 4. Disconnect all the leads of the synchronous motor. 5. Remove the 2 screws which fasten the synchronous motor. (See Fig. 27) 6. Re-install the components by referring to the removal procedure, above. 18 Room Air Conditioner Figure 24 Figure 25 Figure 26 Figure 27