LG WKEX200HRA Owners Manual - Page 56

us_main.book.book Page 55 Tuesday, April 6, 2021 1:44 PM ENGLISH TROUBLESHOOTING 55 Problem Lint on clothes. Excess static in clothes after drying. Clothes have damp spots after a dry cycle. Possible Cause & Solution Lint filter not cleaned properly. • Remove the lint from the filter before every load. With the lint removed, hold the filter up to a light to see if it is dirty or clogged. If it looks dirty, follow the cleaning instructions in the MAINTENANCE section. With some loads that produce high amounts of lint, it may be necessary to clean the filter during the cycle. Laundry not sorted properly. • Some fabrics are lint producers (i.e., a fuzzy white cotton towel) and should be dried separately from clothes that are lint trappers (i.e., a pair of black linen pants). Excess static in clothes. • Use a fabric softener to reduce static electricity. Be sure to follow the manufacturer's instructions. Overdrying a load of laundry can cause a buildup of static electricity. The appliance is overloaded. • Divide extra large loads into smaller loads for drying. Tissue, paper, etc., left in pockets. • Check pockets thoroughly before washing and drying clothes. Fabric softener is not used or is used incorrectly. • Use a fabric softener or the Reduce Static option, if available, to reduce static electricity. Be sure to follow the manufacturer's instructions. Clothes dried too long (overdried). • Overdrying a load of laundry can cause a buildup of static electricity. Adjust settings and use a shorter drying time. Select a lower dry level setting, if necessary. Drying synthetics, permanent press, or synthetic blends. • These fabrics are naturally more prone to static buildup. Try using fabric softener, or use a lower dry level setting and/or shorter time settings. Very large load or very small load. Single large item such as a blanket or comforter. • If items are too tightly packed or too sparse the sensor may have trouble reading the dryness level of the load. Use a Time Dry cycle for very small loads. • Large, bulky items such as blankets or comforters can sometimes wrap themselves into a tight ball of fabric. The outside layers will dry and register on the sensors, while the inner core remains damp. When drying a single bulky item, it may help to pause the cycle once or twice and rearrange the item to unwrap and expose any damp areas. • To dry a few remaining damp items from a very large load or a few damp spots on a large item after a sensor cycle has completed, empty the lint trap, and then set a Time Dry cycle to finish drying the item(s). Steam Function Problem Water drips from nozzle when Steam cycle starts. Steam does not generate, but no error code is shown. Water drips from door during Steam cycle. Possible Cause & Solution This is normal. • This is steam condensation when Steam cycle starts. The dripping water will stop after a short time. Water level error. • Unplug dryer and call for service. This is normal. • Condensation will normally form on the inside of the dryer door during steam operation. Some condensation may drip out the bottom of the door.