LG WM1355HR Owner's Manual - Page 29
Before Calling For Service
UPC - 048231010382
View all LG WM1355HR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
TROUBLESHOOTING BEFORE CALLING FOR SERVICE (cont.) Problem Wrinkling Water in the washer drains slowly or not at all, or the display shows: Possible Causes • Washer not unloaded promptly. • Washer overloaded. • Hot and cold water inlet hoses are reversed. • Drain hose is bent, pinched, or clogged. • The drain filter is clogged. Solutions • Always remove items from the washer as soon as the cycle is completed. • The washer can be fully loaded, but the drum should not be tightly packed with items. The door of the washer should close easily. • Hot water rinse can set wrinkles in garments. Check the inlet hose connections. • Make sure the drain hose is free of clogs, kinks, etc., and is not pinched behind or under the washer. • Clean the drain filter. See the Care and Cleaning section. Washer fills with water slowly or not at all, or the display shows: Washer will not turn on Washer won't spin, or the display shows: Door will not unlock when cycle is stopped or paused Wash cycle time is longer than usual Musty or mildewy odor in washer • Water supply taps are not open fully. • Water line hoses are kinked, pinched, or bent. • Water inlet filters are clogged. • Water pressure to tap or house is too low. • Power cord is not properly plugged in. • House fuse is blown, circuit breaker has tripped, or power outage has occurred. • Make sure that the water taps are open fully. • Make sure the hoses are not kinked or pinched. Be careful when moving the washer. • Clean the inlet filters. See the Care and Cleaning section. • Check another faucet in the house to make sure that household water pressure is adequate. • Make sure that the plug is plugged securely into a grounded, 3-prong, 120-VAC, 60-Hz. outlet. • Reset circuit breaker or replace fuse. Do not increase fuse capacity. If the problem is a circuit overload, have it corrected by a qualified electrician. • The door is not closed properly. • Interior temperature of washer is too high. • Water level in washer is too high. • The washer automatically adjusts the wash time for the amount of laundry, water pressure, water temperature, and other operating conditions. • Make sure that the door is closed properly and press the START/PAUSE button. After starting a cycle, it may take a few moments before the drum begins to turn or spin. The washer will not spin unless the door is locked (DOOR LOCK will appear in the display). • If the door is closed and locked and the open door error message is displayed, call for service. • The washer door has a safety lock to prevent burns. Allow the washer to cool until the DOOR LOCK indicator turns off in the display. • Allow the washer to complete the programmed cycle, or run the DRAIN & SPIN cycle to drain the water. • This is normal. The washer adjusts cycle time automatically to provide optimal results for the selected cycle. • Incorrect or too much detergent has been used. • Inside of tub not cleaned properly. • Use only HE (High-Efficiency) detergent in accordance with the manufacturer's instructions. • Never use more than TWO tablespoons (1 oz. or 30 ml) of detergent or more than TWO teaspoons (½ oz. or 15 ml) of softener or bleach. • Run the TUB CLEAN cycle regularly. Be sure to wipe around and under the door seal frequently. • Clean around door seal/glass to prevent odor or mildew 1. wipe dry the door seal/glass and the door opening area 2. wipe around the inner drum/door seal and the lower door seal 29