LG WM2688HNM Owners Manual - Page 15

• SteamFreshTM cycle • For slightly wrinkled clothes which have been stored for an extended time. It makes wrinkled clothes easier to iron (Do not load wet clothes). • Wrinkles and odors will be reduced. • To use the SteamFresh TM cycle : 1. Turn on the washer and select the SteamFreshTM cycle. 2. Load 5 items or less and close the door. NOTE: Wipe the water off the drum. 3. Press the Steam button repeatedly until the correct number of items is displayed. _ Press the Steam button. 4. Press the Start/Pause button. • After the SteamFreshTM cycle is complete, the drum will tumble for 30 minutes to prevent rewrinkling. Press any button to unload the items. The Remote Laundry Monitor (RLM) will display "End" for 2 minutes and then will display "---" for 28 minutes. • After the SteamFreshTM cycle is complete, open the door and allow it to cool down for best results. Precautionary Notes: - The SteamFresh TM cycle is not like other washing or drying cycles. - Due to the characteristics of cotton fibers, this cycle is not recommended for 100% cotton clothing. - Remove stains from clothing before using the SteamFresh TM cycle to prevent permanently setting the stains by high heat. - Be sm'e the faucet is open. This cycle uses a little water to produce steam. - Be careful not to touch the door. It can be very hot. - Do not load the following items: Wool, blankets, leather jackets, silk, wet clothes, lingerie, foam products, or electric blankets. - After removing clothes from the SteamFresh TM cycle they may feel slightly damp. Wait at least 10 minutes before putting the clothes on. - Best results are achieved when articles are of similar size and fabric type. Do not overload. _k CAUTION: - Do not reach into the washer while operating. Steam can cause severe burns. - Keep pets away from the washer. 6. Wash/Rinse Temperature • Select a water temperature based on the type of load you are washing. • Follow the fabric care label and chart below for best results. Warm Most loads • Warm rinses leave the loads dryer than cold rinses. Warm rinses increase wrinkling. • In cold climates, a warm rinse makes the load more comfortable to handle. • Cold rinses save energy. • The Cold rinse temperatures depend on the cold water at your faucet. • This washer automatically adjusts the water level for the type and size of wash load for best results. It may seem there is no water inside the drum in some cycles, but this is normal. 7. Spin speed • To change the spin speed, press the Spin Speed button repeatedly to cycle through available options. • To start Drain/Spin cycle: 1. Press Power @ button to turn on. 2. Press 8pin Speed button only. 3. Press 8tart/Pause @ button. 8. Soil Level • To change the soil level, press the Soil Level button repeatedly until the desired setting is on. 9. Beeper • Press repeatedly to adjust the volume of the Beeper. 1 5'