LG WM3150HVC Owner's Manual - Page 14
Connecting the water lines
View all LG WM3150HVC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
14 INSTALLATION INSTRUCTIONS Connecting the water lines 1 Check the rubber seals on both sides of the hose. - Insert a rubber seal into the threaded fittings on each hose to prevent leaking. Rubber seal Rubber seal Water hose (To faucet) Water hose (To water inlet on the washing machine) 2 Connect the water supply hoses to the HOT and COLD water faucets tightly by hand and then tighten another 2/3 turn with pliers. - Connect the blue hose to a cold water faucet and the red hose to a hot water faucet. WARNING yy Do not overtighten. Damage to the coupling can result. 3 After connecting inlet hose to water faucets, turn on the water faucets to flush out foreign substances (dirt, sand or sawdust) in the water lines. Let water drain into a bucket, and check the water temperature. 4 Connect the hoses to the water inlets tightly by hand and then tighten another 2/3 turn with pliers. - Connect the blue hose to the cold water inlet and the red hose to the hot water inlet. Cold water inlet Hot water inlet WARNING yy Do not overtighten. Damage to the coupling can result. 5 Check for leaks by turning on the faucets. - If water leaks, check steps 1 to 4 again. NOTE yy For your safety, and for extended product life, use only authorized components. The manufacturer is not responsible for product malfunction or accidents caused by the use of separately purchased unauthorized parts. yy Use new hoses when you install the washing machine. Do not reuse old hoses. Use only the inlet hoses provided with the washer. LG does not recommend the use of aftermarket hoses. yy Periodically check the hoses for cracks, leaks and wear, and replace the hoses every 5 years. yy Do not stretch the water hoses intentionally, and make sure that they are not crushed by other objects. yy Water supply pressure must be between 14.5 PSI and 116 PSI (100~800 kPa). If the water supply pressure is more than 116 PSI, a pressure reducing valve must be installed. yy To provide optimum washing performance the hot water temperature should be set at 120-135°F (48-57°C) and the cold at 60°F (15°C).