LG WM3900HWA Owners Manual - Page 48
Rinse+Spin, Control Lock
View all LG WM3900HWA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
48 TROUBLESHOOTING Problem Water in the washer drains slowly or not at all and Possible Cause Drain hose is kinked, pinched, or clogged Drain discharge is more than 96 inches (2.4 m) above bottom of washer. Control error. Water level is too high due to a faulty water valve. The water level sensor is not working correctly. A motor error has occurred. If the washing machine detects too many suds, it displays this error code and adds a Suds Reducing cycle. This adds about 2 hours to the cycle time. If too many suds are detected during spinning, the washing machine stops to help prevent leaking. The water level too low or high compared to the size of the load. Inlet hose, drain hose or drain pump frozen. Control Lock is activated. Tub Clean is activated or the washer drum needs cleaning. Solutions ••Make sure the drain hose is free of clogs or kinks, and is not pinched behind or under the washer. ••The end of the drain hose should be no more than 96 inches (2.4 m) above the bottom of the washer. ••Unplug the washer and wait 60 seconds. Reconnect power and try again. If the error reappears, call for service. ••Close the water faucets, unplug the washer, and call for service. ••Close the water faucets, unplug the washer, and call for service. ••Allow the washer to stand for 30 minutes and then restart the cycle. If the LE error code persists, call for service. ••Do not add more than the manufacturer's recommended amount of detergent. To remove suds, turn the washer off and on, then run the Rinse+Spin cycle. ••The water level sensor ir not working correctly. Unplug the power cord and call for service. ••See the Care in Cold Climates section for instructions. ••This is not an error code. This code indicates that the Control Lock is activated. Press and hold Control Lock for 3 seconds. ••This is not an error code. This code indicates that the Tub Clean is activated or needed. Use the Tub Clean cycle to clean the washer drum.