LG XBV613 Operation Guide - Page 11

Preparation RF coaxial connection Connect the RF.OUT jack on the DVD+VCR to the antenna in jack on the TV using the supplied 75-ohm Coaxial Cable (R). Optional TV Connections These connections support only DVD playback. The tuner and VCR still output through the RF.OUT (R) or DVD/VCR OUT (A, V) jacks. How to set the DVD+VCR's RF output channel 1. When the DVD+VCR is turned off, press and hold CH (V/v) on the front panel for more than five seconds. "RF03" or "RF04" appears in the display window. 2. Press CH (V/v) to change the RF output channel (RF03 or RF04). Tune the TV to this channel. 3. Turn off the DVD+VCR. Audio/Video connection 1. Connect the DVD/VCR VIDEO OUT jack on the DVD+VCR to the video in jack on the TV using the video cable supplied (V). 2. Connect the Left and Right DVD/VCR AUDIO OUT jacks on the DVD+VCR to the audio left/right in jacks on the TV (A1) using the supplied audio cables. Note: If you use this connection, set the TV's source selector to VIDEO. S-Video connection Connect the S-VIDEO OUT jack on the DVD+VCR to the S-Video in jack on the TV using the optional S-Video cable (S). Component Video / Progressive Scan connection If your television is a high-definition or "digital ready" television, you may take advantage of the DVD+VCR's progressive scan output for higher video resolution. Connect the COMPONENT/PROGRESSIVE SCAN VIDEO OUT jacks on the DVD+VCR to the corresponding in jacks on the TV using an optional Y Pb Pr cable (C). Notes: • Progressive scan does not work with the analog video connections (yellow VIDEO OUT jack and S-VIDEO OUT jack). • When you use Component Video signal, set the Progressive Scan to "Off" on the setup menu. • If your TV does not accept the Progressive Scan format, the picture will appear scrambled. Audio connection Connect the Left and Right AUDIO OUT jacks of the DVD+VCR to the audio left/right in jacks on the TV using the supplied audio cables (A2). 11