LG XBV613 Operation Guide - Page 5

AAA Introduction Introduction To ensure proper use of this product, please read this owner's manual carefully and retain for future reference. This manual provides information on the operation and maintenance of your DVD+VCR. Should the unit require service, contact an authorized service location. Moisture Condensation Never operate the DVD+VCR immediately after moving it from a cold location to a warm location. Leave it for two or three hours without operating it. If you use the DVD+VCR in such a situation, it may damage discs/tapes and internal parts. Symbol Used in this Manual Note: Tip: Indicates special notes and operating features. Indicates tips and hints for making the task easier. A section whose title has one of the following symbols is applicable only to the disc represented by the symbol. ALL DVD ACD MP3 WMA DivX All discs listed below DVD and finalized DVD±R/RW Audio CDs MP3 files WMA files DivX files About the Symbol Display " " may appear on your TV display during operation and indicates that the function is not permitted by this unit or the disc. Notes on Discs Handling Discs Do not touch the playback side of the disc. Hold the disc by the edges so that fingerprints do not get on the surface. Never stick paper or tape on the disc. AAA Storing Discs After playing, store the disc in its case. Do not expose the disc to direct sunlight or sources of heat and never leave it in a parked car exposed to direct sunlight. Cleaning Discs Fingerprints and dust on the disc can cause poor picture quality and sound distortion. Before playing, clean the disc with a clean cloth. Wipe the disc from the center out. Do not use strong solvents such as alcohol, benzine, thinner, commercially available cleaners, or anti-static spray intended for older vinyl records. About the Remote Control Operation Range Point the remote control at the remote sensor and press the buttons. Distance: About 23 ft (7 m) from the front of the remote sensor. Angle: About 30° in each direction of the front of the remote sensor. Battery installation Detach the battery cover on the rear of the remote control, and insert two (R03/AAA) size batteries with 3 and # aligned correctly. Caution: Do not mix old and new batteries and never mix different types of batteries such as standard, alkaline, etc. 5