Lacie 4big Quadra User Manual - Page 11

Setting Up Your LaCie 4big - raid setup

Get Lacie 4big Quadra PDF manuals and user guides View all Lacie 4big Quadra manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

LaCie 4big Quadra Enterprise Class • Design by Neil Poulton User Manual 2. Setting Up Your LaCie 4big This section covers the installation and configuration of your LaCie 4big Enterprise Class. Follow the steps below to power on and configure your LaCie 4big: Step 1 - Connect the Interface Cable (section 2.1) Step 2 - Turn On the 4big (section 2.2) Step 3 - Configuring RAID (section 3) TECHNICAL NOTE: The LaCie 4big Quadra Enterprise comes with no encryption configured. If you want to set up encryption, install the LaCie Desktop Manager and refer that application's user manual. IMPORTANT INFO: LaCie Enterprise Class encryption offers a very high level of protection for your most important data. Due to the strength of the encryption, data recovery will not be possible in the unlikely event of disk or part failure. Setup page 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
LaCie 4big Quadra Enterprise Class
• D
ESIGN
BY
N
EIL
P
OULTON
Setup
User Manual
page 11
This section covers the installation and configuration of your LaCie
4big Enterprise Class. Follow the steps below to power on and con-
figure your LaCie 4big:
TECHNICAL NOTE:
The LaCie 4big Quadra Enterprise comes with
no encryption configured. If you want to set up encryption, install the
LaCie Desktop Manager and refer that application’s user manual.
IMPORTANT INFO:
LaCie Enterprise Class encryption offers a
very high level of protection for your most important data. Due to
the strength of the encryption, data recovery will not be possible in
the unlikely event of disk or part failure.
2. Setting Up Your LaCie 4big
Step 1
–
Connect the Interface Cable
(section
2.1
)
Step 2
–
Turn On the 4big
(section
2.2
)
Step 3
– Configuring
RAID
(section
3
)