Lantronix C4110-4848 Installation Guide Rev C PDF 1.20 MB - Page 33

Transition Networks C4110 Install Guide Safety Instructions for Rack Mount Installations The instructions below (or similar) are intended for rackmount installation environments: 1. Elevated Operating Ambient: if installed in a closed or multi-unit rack assembly, the operating ambient temperature of the rack environment may exceed room ambient. Install the equipment in an environment compatible with the maximum ambient temperature (Tma) specified. 2. Reduced Air Flow: install the equipment in a rack so that the amount of air flow required for safe operation is not compromised. 3. Mechanical Loading: Mount the equipment in the rack so that a hazardous condition does not occur due to uneven mechanical loading (weight distribution/rack balance). 4. Circuit Overloading: give consideration to the connection of the equipment to the supply circuit and the effect that overloading of the circuits might have on overcurrent protection and supply wiring. Consider all equipment nameplate ratings when addressing this concern. 5. Reliable Earthing: maintain reliable earthing of rack-mounted equipment; pay particular attention to supply connections other than direct connections to the branch circuit (e.g., use of power strips). Record of Revisions Rev Date Notes A 3/2/15 Initial release for v 1.2.4. B 9/12/16 Update for C4110 v1.2.6; add Vendor Specific Info to DMI; add C4110 support in Focal Point; update driver installation and contact information. C 6/30/17 Remove Loopback and update LPT description. Trademark Notice: All trademarks and registered trademarks are the property of their respective owners. Copyright restrictions: © 2015-2017 Transition Networks. All rights reserved. No part of this work may be reproduced or used in any form or by any means - graphic, electronic or mechanical - without written permission from Transition Networks. 33572 Rev. B https://www.transition.com/ Page 33 of 33