Lantronix EDCA-DIO-01 Quick Start Guide Rev C PDF 301.64 KB - Page 2
Switch Software Configuration
View all Lantronix EDCA-DIO-01 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Lantronix EDCA-DIO-01 Quick Start Guide The figure below shows a SISPM1040-384-LRT-C Ethernet switch, EDCA-DIO-01, and power supply in a single cabinet/enclosure. Warning: Ensure that the target alarm input can accept the applied voltage (12VDC in this example). Note: If installing external audio or visual alarm equipment, place that equipment in series with the 22365 or switch that came with the cabinet. EDCA-DIO-01Install Procedure 1. Mount a mechanical door closure contact switch near the enclosure door so that the opening and closing of the door will trigger the switch. 2. Connect the 12VDC Relay port to the sensor or door contact closure switch. 3. Connect the ALARM Out port to the Digital input port on the Ethernet Switch. 4. Connect to DC Input power last. 5. Verify that the PWR LED is lit. Switch Software Configuration When the EDCA-DIO-01 is installed with a Lantronix managed hardened Ethernet PoE switch, you can set up alarm notifications and clear the logged alarm from either the switch Web Interface or CLI. See the related manual for your switch model. Contact Us: 7535 Irvine Center Drive, Suite100, Irvine, CA 92618, USA. Toll Free: 800-526-8766. Phone: 949-453-3990. Fax: 949-453-3995. Technical Support Phone: +1.952.358.3601 or 1.800.260.1312; Email: [email protected]. Sales Offices: www.lantronix.com/about/contact. 33796 Rev. C https://www.lantronix.com/ Page 2 of 2