Lantronix EDS8PR EDS - User Guide - Page 73
When using ATDT and ATDP, enter 0.0.0.0 to switch to the Command Line Interface CLI. Once
View all Lantronix EDS8PR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
9: Line and Tunnel Settings Table 9-20 Modem Emulation Commands and Descriptions (continued) Command (continued) ATS0=n ATA A/ Description Accept incoming connection. N value of 0-Disable N value of 1-Connect automatically N value of 2+-Connect with ATA command. Answer incoming connection (if ATS0 is 2 or greater). Repeat last valid command. For commands that can take address information (ATD, ATDT, ATDP), the destination address can be specified by entering the IP Address, or entering the IP Address and port number. For example, :. The port number cannot be entered on its own. For ATDT and ATDP commands less than 255 characters, the EDS replaces the last segment of the IP address with the configured Connect Mode remote station address. It is possible to use the last two segments also, if they are under 255 characters. For example, if the address is 100.255.15.5, entering "ATDT 16.6" results in 100.255.16.6. When using ATDT and ATDP, enter 0.0.0.0 to switch to the Command Line Interface (CLI). Once the CLI is exited by using the CLI exit command, the EDS reverts to modem emulation mode. By default, the +++ characters are not passed through the connection. Turn on this capability using the modem echo pluses command. To configure modem emulation for a specific tunnel: 1. Select Tunnel on the menu bar, if you are not already in the Tunnel web page. 2. Select a tunnel number at the top of the page. 3. Select Modem Emulation. The Modem Emulation page for the specific tunnel appears. EDS User Guide 73