Lantronix EMG 8500 - Edge Management Gateway EMG User Guide - Page 179
Device Attributes, Remote Access Idle Timeout, Firmware Updates via
View all Lantronix EMG 8500 - Edge Management Gateway manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 179 highlights
8: Services 2. Enter the following: ConsoleFlow Client Enables or disables the ConsoleFlow client. This option is enabled by default, unless an EMG is not configured with a Device ID. When the client is enabled, it will attempt to register with the Registration Host. If this is successful, the client will attempt to establish a connection with the Messaging Host. The General log (see SSH/Telnet/Logging on page 148) will contain messages about connections made to the Registration Host and Messaging Host. Status of Client displays the last time of actions performed by the client. Note that when the client is disabled, it may take as long as 30 seconds for the client to terminate, depending on what actions the client was performing at the time it was disabled. Interval between status Number of minutes between status updates sent from the client to the server. updates Valid values are 1 - 60 minutes. The default is 2 minutes. Interval between FW and Config Checks Number of hours between checks for firmware and configuration updates initiated by the server. Valid values are 1 - 72 hours. The default is 24 hours. Firmware Updates via ConsoleFlow If enabled, firmware updates can be initiated by ConsoleFlow for the EMG. The device will check for updates per the frequency defined by Interval between FW and Config Checks, and if a firmware update is found, the update will be downloaded to the device and applied to the alternate boot bank. Enabled by default. Configuration Updates via ConsoleFlow If enabled, configuration updates can be initiated by ConsoleFlow for the EMG. The device will check for updates per the frequency defined by Interval between FW and Config Checks, and if a configuration update is found, the update will be downloaded to the device and applied to the current boot bank, and the EMG will be immediately rebooted. Enabled by default. Reboot after Firmware If enabled, the EMG will automatically reboot after a successful firmware update Update via ConsoleFlow. Disabled by default. Connect to If Cloud is selected, the ConsoleFlow client uses Cloud server settings. If OnPremise is selected it uses On-Premise server settings. Cloud is selected by default (e.g., by default the ConsoleFlow active connection is Cloud). Device Attributes Device Name Device Description Device ID S/N The device name displayed in the ConsoleFlow server UI. Valid characters are alphanumeric characters, dash "-", and underscore "_". The default is the device type (EMG) with the last 4 characters of the Eth1 MAC address appended. Long description that is displayed in the ConsoleFlow server UI. The unique device identifier. The ID is 32 alphanumeric characters. The ID may be provisioned using Lantronix Provisioning Manager (LPM). Contact Lantronix Tech Support for more information on LPM. Displays the serial number. Remote Access Idle Timeout Remote Access CLI Timeout Remote Access Device Port Timeout Remote Access CLI Connection will be idle timed out after a specified number of seconds as defined in the Seconds field to the right. Enter a value from 1 to 1800 seconds. The default is 600 seconds. Remote Access Device Port Connection will be idle timed out after a specified number of seconds as defined in the Seconds field to the right. Enter a value from 1 to 1800 seconds. The default is 600 seconds. EMG™ Edge Management Gateway User Guide 179