Lantronix Micro Embedded Integration Kit (EIK) - Integration Guide - Page 22

Micro100 Note: CON3 is a PCB-mounted, center-positive 5VDC power supply connector. Technical Specifications Category Memory Serial Flash Serial Interface Board Dimensions Weight Temperature Protocols Supported Network Interface Data Rates Serial Line Formats Modem Control Flow Control Management System Software LEDs Compatibility Power Requirements Table 3-4. Micro100 Technical Specifications Description 256K RAM 512 K 2 TTL serial interfaces (Async). 5V-level signals. Through-hole plated pins, DIL Height: 1.575in (40.00 mm) Width: 1.935in (49.15 mm) (See Drawing) 0.7 ounces Operating range: 0° to +70° C (32 to 158° F) Storage range: -40° to +85° C (-40 to 185° F) ARP, UDP, TCP, Telnet, ICMP, SNMP, DHCP, TFTP, AutoIP, and HTTP RJ45 10/100Base-T 300 bps to 230400 bps Characters: 7 or 8 data bits Stop bits: 1 or 2 Parity: odd, even, none DTR, DCD, CTS, RTS XON/XOFF (software), XON/XOFF Pass Characters to Host CTS/RTS (hardware) None HTTP SNMP (read only) Serial login Telnet login Operational code (ROM): downloadable from a TCP/IP host (TFTP) or over serial port Channel 1 (solid Green = idle, blink = active) Channel 2 (solid Yellow = idle, blink = active) Diagnostics (Red, in combination with Channel 1) Network Link (Green) Ethernet: Version 2.0/IEEE 802.3 5VDC (±5%) regulated @ 200mA Product Information Label The Micro100 ships with a product information label that can be affixed to the host device. The product label contains information about your specific unit, such as its part number, revision number, manufacturing code, and Ethernet address (also referred to as hardware address or MAC address). Revision Number Part Number Manufacturing Code MAC Address Embedded Integration Kit Integration Guide 3-7