Lantronix S3220 Series CLI Reference Guide Rev G PDF 3.07 MB - Page 300

Appendix C: CLI Command Messages Transition Networks ERROR Software version of this card ("cardVersion") is not supported, please upgrade to the same version as the IONMM Getting card version failed The failure get template config handler was called. You attempted a function that is not supported by this version of firmware. 1. Enter another (supported) function at this card's firmware version, or use the "go" command to switch to another card. 2. Upgrade to a newer firmware version. See "TFTP Transfer / Upgrade Commands" on page 204 or "Upgrade / Update Firmware Commands" on page 207. 3. Retry the operation. 4. If the problem persists, contact Technical Support. US/Canada: 1-800-260-1312, International: 00-1- 952-941-7600. The confirm password is not identical with the password! The user name length must be in range [1..64]! The user name must begin with an alphanumeric char! You can only change your own password, not others! You entered a command to create a new system user, but the command failed. 1. Verify the command syntax ("add sysuser name=NAMESTR level=(admin|read-write|read-only) pass=PASSSTR confirmpass=PASSSTR"). 2. Retry the operation, making sure the "pass" and "confirmpass" entries match. See the related command section. 3. If the problem persists, contact Technical Support. US/Canada: 1-800-260-1312, International: 00-1952-941-7600. Cannot set irate because irate is bigger than port speed! Cannot set erate because erate is bigger than port speed! Egress Rate Limit - Web interface and CLI behaviors do not match Web Egress Rate Limit and CLI "show ether config" command rates do not match. At the C3220 > Port 1 > ADVANCED tab > Egress Rate Limit field, you modified the bandwidth allocation display value successfully, but the Web interface and CLI behaviors do not match. For instance, you link up the C3220-1040 copper port at 1000Mfull, and set copper port Egress Rate Limit to 900M. If you then uncheck the copper port "Capabilities Advertised" options of "1000M - Half Duplex" and "1000M - Full Duplex", and set the copper port link up at 100Mfull, in the Web, the copper port Egress Rate Limit will return to "Unlimited"; but in the CLI, the copper port Egress Rate Limit still shows "rate900M" (i.e., the port speed is 100M-full, but you still can display/set the rate limit to rate900M through the CLI). 1. Re-enter the irate / erate command bandwidth settings. 2. Retry the operation. 3. See "Bandwidth Commands" on page 72 for more information. 300 www.transition.com 33473 Rev. G