Lantronix SISTP1040-342-LRT SISTP1040-342-LRT and SISTP1040-382-LRT Install Gu - Page 27

Lantronix SISTP10x0-3xx-LRT Install Guide Declaration of Conformity Declaration of Conformity Manufacture's Name: Lantronix, Inc. Manufacture's Address: 7535 Irvine Center Drive, Suite100, Irvine, CA 92618, USA Declares that the products: SISTP1010-360-LRT, SISTP1010-380-LRT-C, SISTP1040-342-LRT, SISTP1040-382-LRT, SISTG1040-242-LRT, SISTG1040-282-LRT Conform to the following Product Regulations: FCC Part 15 Class A, EN 55032:2012, EN 55024:2010 Directive 2014/30/EU, Directive 2015/863/EU Low-Voltage Directive 2014/35/EU IEC 62368-1:2014 (Second Edition); and/or EN 62368-1:2014/A11:2017; and/or BS EN 62368-1:2014+A11:2017. 2011/65/EU EN 50581:2012 EN 61000-3-2:2014, Class A. EN 61000-3-3:2013. EN 55024:2010. EN 61000-4-2:2009 / IEC 61000-4-2:2008 ED. 2.0. EN 61000-4-3:2006 +A1:2008 +A2:2010 / IEC 61000-4-3:2010 ED. 3.2. EN 61000-4-4:2012 / IEC 61000-4-4:2012 ED. 3.0. EN 61000-4-5:2006 / IEC 61000-4-5:2005 ED. 3.0. EN 61000-4-6:2014 / IEC 61000-4-6:2013 ED. 4.0. EN 61000-4-8:2010 / IEC 61000-4-8:2009 ED 2.0. EN 61000-4-11:2004 / IEC 61000-4-11:2004 ED 2.0. Australian Standard AS/NZS CISPR 22:2009/A1:2010 Class A. Standard(s) for Safety: UL 121201 Nonincendive Electrical Equipment for Use in Class I and II, Division 2 and Class III, Divisions 1 and 2 Hazardous (Classified) Locations, CSA C22.2 NO. 213 Nonincendive Electrical Equipment for Use in Class I and II, Division 2 and Class III, Divisions 1 and 2 Hazardous (Classified) Locations With the technical construction on file at the above address, this product carries the CE Mark I, the undersigned, hereby declare that the equipment specified above conforms to the above Directive(s) and Standard(s). Place: Minnetonka, Minnesota Date: July 28,2021 Signature: Fathi Hakam Full Name: Fathi Hakam Position: Vice President of Engineering User Information Caution: changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class A device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. Test Standard: 47 CFR FCC Rules and Regulations Part 15 Subpart B, Class A Digital Device. ICES-003 Issue 6, Class A. The energy emitted by this equipment was passed CISPR PUB. 22 and FCC Part 15 Subpart B and Canada Standard ICES-003 Issue 6. These devices are open-type devices that are to be installed in an enclosure only accessible with the use of a tool, suitable for the environment. This equipment is suitable for use in Class I, Division 2, Groups A, B, C, and D or non-hazardous locations only. "WARNING - EXPLOSION HAZARD. DO NOT DISCONNECT WHILE THE CIRCUIT IS LIVE OR UNLESS THE AREA IS FREE OF IGNITIBLE CONCENTRATIONS. Temperature code (T-Code) - T4. 33733 Rev. G https://www.lantronix.com/ Page 27 of 31