Lantronix TN-QSFP-40G Series TN-QSFP-40G User Guide Rev D - Page 8
QSFP+ Installation, Cautions, Installing a QSFP+ Module
View all Lantronix TN-QSFP-40G Series manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Lantronix TN-QSFP-40G-xx User Guide QSFP+ Installation Cautions • The QSFP+ tranceiver module is keyed to only be installed one way. However, if forced the wrong way, damage may occur. • Avoid getting dust or other contaminants into the fiber bore of the QSFP+ transceiver module. • Clean the optic surfacees of the optical fiber before you plug them back in to the optical bores of another QSFP+ tranceiver module. • Each port must match the wavelength specifications on the other end of the cable, and the cable must not exceed the specified cable length for reliable communications. Installing a QSFP+ Module 1. Attach an ESD-preventive wrist strap to your wrist and to the ESD ground connector or a bare metal surface on your chassis. 2. Remove the QSFP+ transceiver module from its protective packaging. Note: Do not remove the optical bore dust plugs until directed to do so in a later procedure. 3. Check the slot orientation. Note that for some devices (e.g., S4224) some slots are "upside down" compared to other slots. 4. Position the QSFP+device at the desired installation slot, with the label facing correctly. 5. Carefully slide the QSFP+ device into the slot, aligning it with the internal installation guides. Label side top of SFP module Switch Switch Bale Clasp SFP Module Triangle indicates bottom of SFP cage Fully Inserted SFP 6. Ensure that the QSFP+device is firmly seated against the internal mating connector. To verify that the QSFP+ is seated and latched properly. a) Grasp the QSFP+ by the sides and try to remove it without releasing the latch. b) If the QSFP+ can not be removed, it is installed and seated properly. If the QSFP+ can be removed, reinsert it and press harder with your thumb; repeat if necessary until it is latched securely into the socket. 7. Connect the fiber cable to the fiber port connector of the QSFP+ device. Make sure the QSFP+ release latch is in the up (closed) position when you insert the cable connector into the QSFP+. 8. Remove the dust plug from the connector. Save the dust plug for future use. 9. Attach an appropriate cable into the QSFP+ module port. 10. Attach the other end of the cable into the other device. 11. Observe the status LED(s). See the related manual for details. 33684 Rev. D https://www.lantronix.com/ Page 8 of 16