Lantronix TN-SFP-LX Series TN-SFP-xxx User Guide Rev G - Page 6

Lantronix TN-SFP-xxx User Guide SFP Unpacking Before you start installing the TN-SFP-xxx, verify that the package contains the following items: o One TN-SFP-xxx o One protective foam piece o One Documentation Postcard Notify your sales representative immediately if any of the aforementioned items is missing or damaged. Save the packaging for possible future use. SFP Installation Cautions • The SFP transceiver module is keyed to only be installed one way. However, if forced the wrong way, damage may occur. • The SFP transceiver module may be damaged if directly connected with short fiber cable without an attenuator. • Avoid getting dust or other contaminants into the fiber bore of the SFP transceiver module, as this will cause the optics to not operate properly. • Clean the optic surfacees of the optical fiber before you plug them back in to the optical bores of another SFP transceiver module. See the Fiber Optic Association, Inc. Cleaning Fiber Optic Connections page on the FOA website at www.thefoa.org/tech/ref/termination/cleaning.html for more information. • Each port must match the wavelength specifications on the other end of the cable, and the cable must not exceed the specified cable length for reliable communications. Note that the NM2-FXS-2230-SFP-01 SFP transceiver is sold separately and also as a part of Lantronix NM2-FXS-2230-SFP-01 M.2 100-Base-FX Ethernet Fiber NIC. See the NM2-FXS-2230-SFP-01 manual for more information on the SFP bundled with the M.2 NIC. See the Optical Power Budget calculator at https://www.transition.com/support/library/calculators/. 33477 Rev. G https://www.lantronix.com/ Page 6 of 15