Lantronix TN-USB Series User Guide Rev E PDF 1.50 MB - Page 20

Lantronix TN-USB-FX-01 User Guide 13. TCPChecksumOffloadV6: Enable or disable the device to calculate the TCP checksum of the transmit IPv6 packets and check the TCP checksum of the received IPv6 packets. -Disabled Disable the TCP Checksum Offload -TxEnabled Enable the TCP Checksum Offload for transmit packets -RxEnabled Enable the TCP Checksum Offload for received packets -RxTxEnabled Enable the TCP Checksum Offload for transmit and received packets 14. UDPChecksumOffloadV6: Enable or disable the device to calculate the checksum of the transmit IPv6 packets and check the UDP checksum of the received IPv6 packets. -Disabled Disable the UDP Checksum Offload -TxEnabled Enable the UDP Checksum Offload for transmit packets -RxEnabled Enable the UDP Checksum Offload for received packets -RxTxEnabled Enable the UDP Checksum Offload for transmit and received packets 15. IPChecksumOffloadV4: Enable or disable the device to calculate the IP checksum of the transmit IPv4 packets and check the IP checksum of the received IPv4 packets. -Disabled Disable the IP Checksum Offload -TxEnabled Enable the IP Checksum Offload for transmit packets -RxEnabled Enable the IP Checksum Offload for received packets -RxTxEnabled Enable the IP Checksum Offload for transmit and received packets 16. ArpOffload: When enable this ability, the device will reply the ARP request packet when computer is suspending. This ability is activated only if WOL is enabled. -Disabled Disable ARP Offload -Enabled Enable ARP Offload 17. NSOffload: When enable this ability, the device will reply the neighbor solicitation packet when computer is suspending. This ability is activated only if WOL is enabled. -Disabled Disable NS Offload -Enabled Enable NS Offload 18. AutoDetach: Enable or disable AutoDetach ability. if AutoDetach is enabled, 3 seconds later after Ethernet cable was unpluged, the device will be detached from USB. -Disabled Disable AutoDetach -Enabled Enable AutoDetach -Use EEPROM Setting Disable or enable AutoDetach according to the EEPROM setting 19. MaskTimer: If wake up ability is enabled, the wake up function will delay this time to active. -0,4,8,12,16,20,24,28 seconds 20. WolLinkSpeed: Set the Ethernet link speed when device sleeps if wake up ability is enabled. -10 Mbps First The Ethernet link speed works on 10 Mbps first if available -Use EEPROM Setting Use EEPROM setting to set Ethernet link speed 33589 Rev. E https://www.lantronix.com/ Page 20 of 28