Lantronix WiPort NR WiPort NR - Integration Guide - Page 14

Description and Specifications Ethernet PHY Receiver Input Characteristics (RX+, RX-) Table 2-11. Ethernet Input Characteristics Parameter Full Scale Input Voltage Input Common Mode Specification 3.0 differential pk-to-pk 1.6 - 2.0 Units V V Comments Gain dependent 100Base-TX Transceiver Characteristics (TX+, TX-) The following table displays the 100Base-TX transceiver characteristics. Table 2-12. 100Base-TX Transceiver Attributes Parameter Peak Differential Output Voltage 100M TX mid-level Signal Amplitude Symmetry Signal Rise/Fall Time Rise/Fall Time Symmetry Duty Cycle Distortion Overshot/Undershot Jitter (measured differentially) Ethernet LED1, LED2 current Sym VP VSS TRF TRFS DCD VOS Min Typical Max 0.95 1.05 -50 50 98 102 3.0 5.0 0.5 35 50 65 5 1.4 8.8 14.1 17.0 Units V mV % ns ns % % ns mA Technical Specifications Table 2-13. Technical Specifications Category CPU, Memory Firmware Reset Circuit Serial Interface Serial Line Formats Modem Control Flow Control Network Interface Protocols Supported Management Internal Web Server Average Power Consumption (at 3.3V) Peak Supply Current (at 3.3V) Security Lantronix DSTni-EX 186 CPU, 256 KB zero wait state SRAM 2048 KB Flash or 4096 KB Flash, 16 KB Boot ROM, 1024 KB SRAM Upgradeable via TFTP and serial port Reset In is low active. Minimum reset pulse width is 2 ms at IIL = -500 µA CMOS (Asynchronous) 3.3V - level signals Speed software selectable (300 bps to 921600 bps) 7 or 8 data bits, 1-2 Stop bits, Parity: odd, even, none DTR, DCD XON/XOFF (software), CTS/RTS (hardware), none 10/100 Ethernet ARP, UDP, TCP, Telnet, ICMP, SNMP, DHCP, BOOTP, Auto IP, HTTP, SMTP, TFTP Internal web server, SNMP (read only) Serial login, Telnet login, DeviceInstaller software Serves web pages WEB storage capacity: 1.2 MB (or 3.2 MB) 750 mW (Regular performance. No data transfer.) 420 mA Password protection, locking features WiPort NR™ Integration Guide 14