Lantronix xPico 200 Evaluation Kit xPico 200r Certification Firmware Instructi - Page 5
Overview, Requirements for Leveraging Lantronix xPico 200 Certificates, Disqualifications
View all Lantronix xPico 200 Evaluation Kit manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Overview This document provides instructions on leveraging Lantronix® xPico® certificates. In many cases, the Lantronix modular transmitter certification can be leveraged without acquiring full recertification effort in products that use the Lantronix module. The xPico 200 series has modular approval for FCC, IC, EU, Japan, China and Australia/New Zealand. All xPico certificates can be found in the xPico 200 module documentation at https://www.lantronix.com/products/xpico-200/#tab-docs-downloads. It is recommended that you consult with your certification laboratory to develop your certification plan for your product that includes the xPico 200 series module. The xPico 200 series module certification tests were completed at Bureau Veritas in Hsinchu, Taiwan. Requirements for Leveraging Lantronix xPico 200 Certificates The following conditions are required to leverage Lantronix modular transmitter certifications: Following the antenna and layout instructions in the xPico 200 Series Integration Guide. Using antennas of similar type and equal or less gain than the antennas listed in the xPico 200 Series Integration Guide. Positioning the xPico 200 module at least 20 cm from a human body and the transmitting antennas at least 20 cm from all other transmitters. Lantronix has not completed SAR testing on the xPico 200 module. Running EMC tests including the FCC 15-part B and EN 301 489 -1/-17. When leveraging the modular certification, the transmitter and receiver-specific tests normally do not need to be performed. Placing certifications for the xPico 200 transmitter IDs for various regions on the endproduct label according to conditions listed in the Compliance section of the xPico 200 Series Data Sheet. See https://www.lantronix.com/products/xpico-200/#tab-docsdownloads. Running two certification testing modes. See Certification Test Modes. Disqualifications to Leveraging Lantronix xPico 200 Certificates The following conditions disqualify the leveraging of Lantronix xPico 200 certifications: Using a different type of antenna than that shown in the xPico 200 Series Integration Guide. Using an antenna with higher gain than the antennas called out in the xPico 200 Series Integration Guide. Installing the xPico 200 module antenna in a location where it is expected to be less than 20 cm from a human body. Under this scenario, SAR testing would need to be completed. Installing the xPico 200 module antenna within 20 cm of another transmitter module. Installing the xPico 200 module in a country or region not referenced in the Compliance section of the xPico 200 Series Data Sheet. See https://www.lantronix.com/products/xpico-200/#tab-docs-downloads. xPico® 200 Certification Firmware Instructions 5