Lenovo A600 Lenovo IdeaCentre A600 Quick Reference V1.0 - Page 1

Connect the power adapter to the computer and the electrical outlet as shown above. Press the power button where is located on the side of this computer to turn it on. Adjust the computer display to your viewing preference. Be sure to read and understand the information in the Safety and Warranty Guide before using this product. Note: Different computer models are shipped with different items. Be sure that you have all of the components shown above available for your computer. Follow all installation instructions for your computer before you turn it on and use it. Note: Different computer models are shipped with different items. Be sure that you have all of the components shown above available for your computer. Power connector Ethernet connector TV tuner (Select models only) USB ports (4) Computer instruction 6 10 9 8 1 7 2 5 3 4 1 Power button 2 USB ports (2) 3 Headphone connector 4 Microphone connector 5 Optical drive slot 6 Camera 7 Brightness down touch button 8 Brightness up touch button 9 LCD On/Off 10 Optical drive eject touch button Note: The buttons located on the bottom right of screen are touch button. When you use your finger to touch them, the indicator will be light. But if you touch the wrong button, the screen might be turn off. Then you need to turn on the screen again. Important information about using this computer Do not hold the stand and carry it upside down. Otherwise, it might damage the joint of the stand. Hold the computer tightly when you carry it. Power button The computer is easy to fall over and damage, if the view angle is over than 15° backward. The computer is easy to fall over and damage the screen, if the view angle is over than 5° forward and the glass pieces might hurt people. Don't put your hand on the joint of the stand when you're adjusting the computer display angle. To insert a disc, turn the data side toward the front of the computer (label side backward) and slide the disc into the drive slot. To eject a disc, make sure the power is turned on and then press the eject touch button on the bottom right of the screen. Don't insert 3 inch optical disk into the drive slot. Or the disk might cannot be ejected. Wireless Keyboard and Mouse instruction 1 1 Unpack and verify the contents of the box. Front view 2 Open Close 2 Install 2 batteries in the keyboard battery compartment. ON/OFF Wireless Reset button Ajust the cursor move speed Rear view Open the battery compartment cover 3 3 Note: If connection is not established successfully, repeat the same steps. Notes: 1) In the process of establishing a connection, it is recom mended to keep the distance between the keyboard, mouse, and computer to less then 25 cm (10 inches). 2) The effective working distance of the wireless keyboard and mouse is 1.5m (5 feet). If the wireless device does not work, do the following: 1. Be sure there is no physical interference between the wireless device and the computer. 2. Restart the computer, and verify the system devices are functional. 3. Repeat the procedure for establishing the Bluetooth connection. 4. Replace the batteries. 5. Do not place the computer under a metal surface or table. 6. Be sure that there are no high electromagnetic fields close by, such as a speaker, other remote control, or cordless phone. 7. Do not place the keyboard, mouse and remote control in a slanted, overturn or stand position. 8. Remove all batteries when you are not using the keyboard, mouse and remote control for an extended period of time. 9. Clean the electrolyte, if there is leak from battery. 10. Be sure to use known, good batteries to ensure the remote works properly and to avoid damaging the Remote Control. 11. The indicator light color of the keyboard power button is Orange normally. It will become Red color when the power is low. You need to change the battery at this moment. e LVT Adjust the keyboard stand to a comfortable level. 4 After installing the batteries, press the keyboard power key. 5 Turn on the computer. Press the Fn + F11 keys on the keyboard to establish the wireless keyboard connection, after about 5-10 sec- onds. Battery compartment AA Battery Install 2 batteries in the battery compartment. 4 Turn on the mouse power switch. Turn off the mouse power switch when you are not using it. 5 Press the wireless reset button on the mouse. Turn the mouse to back ON OFF connect Turn on the computer. Press the Wireless Reset button on the mouse to establish the wireless mouse connection, after about 5-10 seconds. There are touch buttons and touch panel on the top right of the keyboard. Use the touch panel similar with the common mouse. The Touch buttons are as following: Multimedia play key: Open the Mediaplay. e Internet key: Open IE. E-Mail Key: Open the E-mail. LVT After starting the Windows operating system, press the LVT key to start the program. You can then learn to use this featured software designed for the Lenovo home PC with integrated Lenovo core technology, and you can also use any other installed programs on the computer. Dormancy. Stop. Go to the previous track. Play or pause. Go to the next track. Mute. Volume Down. Volume Up. Version: V1.0 31036504