Lenovo IdeaCentre Q200 Q200 Hardware Maintenance Manual - Page 41

Replacing the microprocessor

Get Lenovo IdeaCentre Q200 PDF manuals and user guides View all Lenovo IdeaCentre Q200 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 41 highlights

Chapter 7. Replacing hardware 21. Install the heat sink and fan assembly on the system board. 22. Connect the heat sink and fan assembly cable to the new system board. See the system board illustration for your machine type at "Identifying parts on the system board". 23. Install the new system board into the chassis and align the screw holes with those in the chassis. Insert and tighten the screws that secure the system board. 24. Connect all cables to the system board. See the system board illustration for your machine type at "Identifying parts on the system board" . 25. Refer to the "Completing the installation". Replacing the microprocessor Attention Do not remove the computer cover or attempt any repair before reading the "Important safety information" in the Safety and Warranty Guide that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Safety and Warranty Guide or HMM, go to the Support Web site at http://consumersupport.lenovo.com. To replace the heat sink assembly: 1. Open the computer cover. Refer to "Opening the computer cover". 2. Pivot the drive bay assembly upward to gain access to the microprocessor. 39

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
Chapter 7. Replacing hardware
39
21. Install the heat sink and fan assembly on the system board.
22. Connect the heat sink and fan assembly cable to the new system
board. See the system board illustration for your machine type at
“Identifying parts on the system board”.
23. Install the new system board into the chassis and align the screw holes
with those in the chassis. Insert and tighten the screws that secure the
system board.
24. Connect all cables to the system board. See the system board
illustration for your machine type at “Identifying parts on the system
board” .
25. Refer to the “Completing the installation”.
Replacing the microprocessor
Attention
Do not remove the computer cover or attempt any repair before
reading the “Important safety information” in the
Safety and Warranty
Guide
that was included with your computer or in the
Hardware
Maintenance Manual
(HMM) for the computer. To obtain copies of
the
Safety and Warranty Guide
or
HMM
, go to the Support Web site at
To replace the heat sink assembly:
1.
Open the computer cover. Refer to “Opening the computer cover”.
2.
Pivot the drive bay assembly upward to gain access to the
microprocessor.