Lenovo Tab 2 A7-30 (English) Hardware Maintenance Manual - Lenovo TAB 2 A7-30 - Page 25
Power system checkout, Checking the Computer AC Charger - tablet
View all Lenovo Tab 2 A7-30 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
General checkout Power system checkout To verify a symptom, follow the steps below: 1. Turn off the computer. 2. Remove the battery pack. 3. Connect the AC adapter. 4. Make sure that power is supplied when you turn on the computer. 5. Turn off the computer. 6. Disconnect the AC adapter and install the charged battery pack. 7. Make sure that the battery pack supplies power when you turn on the computer. If you suspect a power problem, see the appropriate one of the following power supply checkouts: • "Checking the Computer AC Charger" on page 21 • "Checking the internal battery status" on page 22 Checking the Computer AC Charger When you use the computer AC Charger to charge the tablet but no power is charged, see the instructions in this topic to check the computer AC Charger. To check the computer AC Charger, do the following: 1. Disconnect the micro-USB cable from the tablet. 2. Measure the output voltage across the connector marked B of the micro-USB cable. Refer to the following figure: 1 2 3 (5V) Pin Voltage (V dc) 1 Ground 2 0 3 +5 Note: The output voltage across pin 3 of the micro-B connector might be different from the one you are servicing. 3. If the voltage is not correct, replace the micro-USB cable. 4. If the voltage is acceptable, replace the system board. 21