Lenovo ThinkCentre E50 Hardware Maintenance Manual - Page 62
Using the Setup Utility, on, Diagnostic Error Code - review
View all Lenovo ThinkCentre E50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
Diagnostic Error Code 000-196-XXX BIOS test halt, error threshold exceeded 000-197-XXX BIOS test warning 000-198-XXX BIOS test aborted 000-199-XXX BIOS test failed, cause unknown 000-250-XXX BIOS APM failure 000-270-XXX BIOS ACPI failure 001-000-XXX System Test Passed 001-00X-XXX System Error 001-01X-XXX System Error 001-024-XXX System Addressing test failure 001-025-XXX System Checksum Value error 001-026-XXX System FLASH data error 001-027-XXX System Configuration/Setup error FRU/Action 1. Press F3 to review the log file 2. Re-start the test to reset the log file 1. Make sure the component that is called out is connected and/or enabled. See Chapter 6, "Using the Setup Utility," on page 49 2. Re-run test 3. Replace the component that is called out in warning statement 4. Replace the component under test 1. Make sure the component that is called out is connected and/or enabled. See Chapter 6, "Using the Setup Utility," on page 49 2. Flash the system and retest. See "Flash update procedures" on page 337 3. Go to "Undetermined problems" on page 80 1. Go to "Undetermined problems" on page 80 2. Flash the system and re-test 3. Replace component under function test 1. Flash the system. See "Flash update procedures" on page 337 2. System board 1. Flash the system. See "Flash update procedures" on page 337 2. System board No action System board System board System board 1. Flash the system. See "Flash update procedures" on page 337 2. System board 1. Flash the system. See "Flash update procedures" on page 337 2. System board 1. Run Setup 2. Flash the system. See "Flash update procedures" on page 337 3. System board 56 Hardware Maintenance Manual