Lenovo ThinkCentre M58p Hardware Maintenance Manual - Page 63
Audio port Interface Test Passed
View all Lenovo ThinkCentre M58p manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Diagnostic Error Code 030-196-XXX SCSI interface test halt, error threshold exceeded 030-197-XXX SCSI interface test warning 030-198-XXX SCSI interface test aborted 030-199-XXX SCSI interface test failed, cause unknown 035-000-XXX RAID interface Test Passed 035-0XX-XXX RAID interface Failure 035-195-XXX RAID interface Test aborted by user 035-196-XXX RAID interface test halt, error threshold exceeded 035-197-XXX RAID interface test warning 035-198-XXX RAID interface test aborted 035-199-XXX RAID interface test failed, cause unknown 071-000-XXX Audio port Interface Test Passed FRU/Action 1. Press F3 to review the log file 2. Re-start the test to reset the log file 1. Make sure the component that is called out is connected and/or enabled. See Chapter 6 "Using the Setup Utility program" on page 43 2. Re-run test 3. Replace the component that is called out in warning statement 4. Replace the component under test 1. If a component is called out, make sure it is connected and/or enabled. See Chapter 6 "Using the Setup Utility program" on page 43 2. Flash the system and re-test. See "Updating (flashing) BIOS from a disc" on page 276 3. Go to "Undetermined problems" on page 66 1. Go to "Undetermined problems" on page 66 2. Flash the system and re-test. See "Updating (flashing) BIOS from a disc" on page 276 3. Replace component under function test No action 1. RAID signal cable 2. RAID device 3. RAID adapter card, if installed 4. System board Information only Re-start the test, if necessary 1. Press F3 to review the log file 2. Re-start the test to reset the log file 1. Make sure the component that is called out is connected and/or enabled. See Chapter 6 "Using the Setup Utility program" on page 43 2. Re-run test 3. Replace the component that is called out in warning statement 4. Replace the component under test 1. If a component is called out, make sure it is connected and/or enabled. See Chapter 6 "Using the Setup Utility program" on page 43 2. Flash the system and re-test. See "Updating (flashing) BIOS from a disc" on page 276 3. Go to "Undetermined problems" on page 66 1. See "Undetermined problems" on page 66 2. Flash the system and re-test. See "Updating (flashing) BIOS from a disc" on page 276 3. Replace component under function test No action Chapter 7. Symptom-to-FRU index 57