Lenovo ThinkCentre M58p Hardware Maintenance Manual - Page 75
Miscellaneous error messages, Setup/Configuration see Starting the Setup Utility
View all Lenovo ThinkCentre M58p manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
POST Error Message Keyboard error or no keyboard present Memory Test: Memory test fail Press TAB to show POST screen Error: Non-System disk or disk error Replace and press any key when ready Description/Action Cannot initialize the keyboard. Make sure the keyboard is properly connected to the computer and that no keys are held pressed during POST. To purposely configure the computer without a keyboard, set the error halt condition in Setup to HALT ON ALL, BUT KEYBOARD. The BIOS then ignores the missing keyboard during POST. This message displays during a full memory test, counting down the memory areas being tested. If POST detects an error during memory testing, additional information appears. This information gives specifics about the type and location of the memory error. Pressing the TAB key permits the user to toggle between the default POST display screen and a custom POST display screen. The BIOS was unable to find a suitable boot device. Make sure the boot drive is properly connected to the computer. Make sure you have bootable media. Miscellaneous error messages Message/Symptom FRU/Action Changing display colors Display/Monitor Computer will not power-off. See "Hard disk drive boot error" on page 47. 1. Power Switch 2. System Board 3. Riser card, if installed Computer will not RPL from server 1. Ensure that network is in startup sequence as first device or first device after diskette 2. Ensure that network adapter is enabled for RPL 3. Network adapter (Advise network administrator of new MAC address) Computer will not perform a Wake on LAN® (if applicable) 1. Check power supply and signal cable connections to network adapter 2. Ensure that the operating system settings are set to enable Wake on LAN 3. Ensure Wake on LAN feature is enabled in Setup/Configuration (see "Starting the Setup Utility program" on page 43) 4. Ensure network administrator is using correct MAC address 5. Ensure no interrupt or I/O address conflicts 6. Network adapter (advise network administrator of new MAC address) Chapter 7. Symptom-to-FRU index 67