LevelOne HVE-9000 Manual - Page 6

HVE-9001 HDSpider™ Cat.5 HDMI Sender Output Panel HDMI IN: Connect to a HDMI source with a HDMI male-male cable Mode: 0 = HDMI mode with surround sound (up to 7.1ch) audio output 1 = HDMI mode with stereo (2ch) audio output 2 = DVI mode 3 ~ 5 = Not in use 6 = Use default EDID profile 7 = Learn the EDID from the display* Note for EDID (Extended Display Identification Data) learning 1. Connect the display which you want to read EDID with a HDMI cable to HDMI-IN on HVE-9001 and dial MODE to 7 so the HVE-9001 can learn the EDID information from the connected display. The LED on the RJ-45 connector will dim and bright again in a few seconds, which indicates the EDID learning process is complete. 2. Dial MODE clockwise [3] from 7 to 0 or 1 for desirable audio setting and enjoy the experience. DO NOT let the rotary control arrow pass by 6. Doing so will erase the EDID just learned and restore the default EDID profile. Output Panel +5V DC: Connect to 5V 2A DC power supply unit. HDMI Signal OUT: Connect to the HDMI Signal IN of the HVE-9000 or HVE-9900 with a Cat.5e/6 cable. 5