LevelOne KVM-1631 Manual - Page 18

5. On Screen Display User can control the KVM switch by three ways - front panel Control Buttons, OSD (On-Screen Display), or Hot key commands through the Console keyboard. It takes approximately 1-2 seconds for the video signal to refresh after switching computers. Re-synchronization of the mouse and keyboard signals also occurs. This is normal operation and ensures that proper synchronization is established between the Console and the connected computers Hotkey You can conveniently command KVM switch through a simple hot key sequence. To send commands to KVM switch, you must press the hotkey (default Caps Lock) twice within 2 seconds. You will hear a beep sound confirming entering Hotkey mode. If you do not press any key during Hotkey mode over 2 seconds the Hotkey mode will be escaped and back to Normal state. The default hotkey is Caps Lock but you can change hotkey as your application convenience. If you prefer to use other hotkey, please go to OSD menu and change the default hotkey to the other. Note: OSD accepts capital letters only. (Uppercase) Command Space bar Х Ц [1,2,..,8] bank, [01, 02,..,32] port PgUp PgDn B L P R S U Function Bring up the OSD overlay screen Moving up Moving down ■ The first digit is bank number starting with "1". The KVM switch on the Daisy chain line is on bank 1 (the Master). A standalone KVM switch also on bank 1. ■ The second & third digits are port number starting with "01" Previous bank Next bank Turn beep sound on/off To enable/disable the Screen Saving function and 10min auto-logout function. This function is default OFF (Disable). To log out the OSD. If Security is enabled it will show up the Login window waiting for username and password. If Security is disabled it will show up the Status window For SUPERVISOR to set the OSD back to factory default value (except User Security settings). For SUPERVISOR to activate the Auto-Scan function For SUPERVISOR to turn Security function on/off. If the Security is off, we 13