LevelOne PLI-2040 Manual - Page 3
Setup
View all LevelOne PLI-2040 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Front Panel LEDs Power On - Normal operation. Off - No power Sleep - blanking HomePlug On - The PowerLine network is active. This means that at least one other HomePlug device was detected. Off - PowerLine network is not available - no other HomePlug devices were detected. Flashing - Data is being transmitted or received via the PowerLine network. Ethernet On - Ethernet connection is active. Off - No Ethernet connection. Flashing - Data is being transmitted or received via the Ethernet Port. LED Link quality (Data PHY Rate) Green:100Mbps~ (good link quality) Orange:50~99Mbps Red: less 50Mbps (bad link quality) Setup Configuration requires the use of Windows PC. Once configured, any device may be connected to the 200Mbps HomePlug AV Adapter's Ethernet port. To perform configuration, follow the procedures list below. 1. Connect a standard LAN cable from the 200Mbps HomePlug AV Adapter's Ethernet port to your PC. 2. Plug the 200Mbps HomePlug AV Adapter into a power outlet. 3. Wait a few seconds for startup to be completed, and then check the LEDs The Power LED should be ON. The HomePlug LED will be ON if other HomePlug devices are detected, otherwise it will be OFF. The Ethernet LED should be ON. 4. Insert the supplied CD-ROM into your Windows PC, and wait for it to start, select "Utility" from the autorun screen. If it does not start automatically, locate and run SETUP.EXE. 5. Follow the prompts to install the PLI-2040 utility.