Lexmark 21B0807 Setup Sheet - Page 1

Please save this sheet for future reference. *11X1111* 1 Unpack your printer 910 Series ??? http://support.lexmark.com/ Note: Contents may vary. Safety information • Use only the power supply provided with this product or the manufacturer's authorized replacement power supply. • Connect the power supply cord to an electrical outlet that is near the product and easily accessible. • Refer service or repairs, other than those described in the user documentation, to a professional service person. CAUTION: Do not set up this product or make any electrical or cabling connections, such as the power supply or telephone, during a lightning storm. 2 Prepare the printer Connect the power 1 cord. 2 Make sure the Power light is on. 3 Press + to scroll to your language, and then press . 2 1 2 1 4 Install the print cartridges 3 Load paper 1 Lift the paper support and extend the paper exit tray. 2 Load the paper. 3 Lower the paper feed guard, squeeze the paper guide, and slide it to the left edge of the paper. 3 2 1 1 Open the access cover. 2 Remove the photo cartridge from the print cartridge storage unit. 3 Remove the sticker and tape from the bottom of the print cartridges. 4 Open the cartridge lids, insert the cartridges, and snap the cartridge lids closed. 1 1 2 2 5 Close the access cover. 6 Press to print an alignment page. You may discard the alignment page after it prints. Reminder: Save the print cartridge storage unit to protect new or partially used cartridges. Warning: Do not touch the copper contact area on the back or the metal print cartridge nozzles on the bottom. 1 2 3 www.lexmark.com If you are using your printer with a computer, continue with "Install the software"...