Lexmark 2590n Technical Reference - Page 39
Code Commands, Set Code Continuously Print From All Character Chart, Code
UPC - 734646050937
View all Lexmark 2590n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Draft document 2-19 Code Page Code Page Commands Set Code Page Use this printer command to change the active code page. Format ESC [ T n1 n2 n3 n4 Hc Lc Decimal 27 91 84 n1 n2 0 0 Hc Lc Hexadecimal 1B 5B 54 n1 n2 00 00 Hc Lc USAGE NOTES • n1 is a one-byte binary number that is the less significant byte of the two-byte parameter count. • n2 is a one-byte binary number that is the more significant byte of the two- byte parameter count. Zero is a valid count. • n3 and n4 are always 0. • Hc and Lc are two-byte values that specify the code page to be used. See"Code Page Table" on page A-1 for decimal and hexadecimal values. • This command is ignored if an unavailable code page is specified. • To calculate Hc Lc for a code page that is not shown: - Divide the code page number, such as 437, by 256. - The whole number result is the Hc value. - The remainder is the Lc value. - If your code page has an alphabetic character, such as 437G, add 10,000 to the code page number, then divide by 256. Continuously Print From All Character Chart This command prints the next (n = m X 256) characters from the All Characters Chart. Format ESC \ Ln Hn n1 ... nn Decimal 27 92 Ln Hn n1 ... nn Hexadecimal 1B 5C Ln Hn n1 ... nn USAGE NOTES • Identify the number of characters (A) that you want to print.