Lexmark 43J2200 Service Manual - Page 118
Print Quality Service Check, Fuser Temperature: Set to NORMAL.
UPC - 734646134750
View all Lexmark 43J2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 118 highlights
4059-XXX Print Quality Service Check Service Tip: Before troubleshooting any print quality problems do the following: • Install another print cartridge if available before proceeding with the service checks. • Use Tray 1 to test for print quality of the base printer. Select the following menu settings as indicated. Be sure and note the original settings so you can return the printer to the original customer printer setup. • Print Resolution: Set to 300 dpi (print quality problems should be checked at different resolution settings). • Print Darkness: Set to NORMAL. • Toner Saver: Set to OFF. • PQET: Set to OFF. • Fuser Temperature: Set to NORMAL. An incorrect printer driver for the installed software can cause problems. Incorrect characters could print and the copy may not fit the page correctly. Measure all voltages from the connector to printer ground. All voltages measured during the print cycle are measured with the controller board removed while running the print test. 2-91 4059 Service Manual