Lexmark 43J2200 Service Manual - Page 33
or 3. 975 - Unrecognizable Network Card x. Replace, x. Replace Network Card x.
UPC - 734646134750
View all Lexmark 43J2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
4059-XXX Error Code Action 956 Configuration ID Indicates a problem with the Configuration ID. This error occurs because the engine received a configuration ID from the controller software which is not valid for the level of engine code existing in the printer. Setting the configuration ID correctly should fix this error. The ID can be set via the NPA data stream or operator panel. Note: This error is not generated at POR to allow the servicer a method of resetting the configuration ID. However, setting the configuration ID is the only operation that the servicer can perform. See "Setting Configuration ID" on page 3-20. 960 RAM Memory Error Indicates a DRAM Memory Error on the controller board. Replace the controller board. 961 RAM in Slot Replace the SIMM in Slot 1. If this does not fix the 1 is Bad. problem, replace the controller board. 962 RAM in Slot Replace the SIMM in Slot 2. If this does not fix the 2 is Bad. problem, replace the controller board. 964 Emulation Error 965 Emulation Error Indicates a failure within the Download Emulation which is programmed into the code overlay SIMM. The specific error is as follows: 964 - Download Emulation CRC Failure. Checksum Failure. 965 - Download Emulation Outdated, The Download Emulation and the controller code are incompatible. Go to "Disabling Download Emulations" on page 3-3. 975 - 979 Network Card X The following errors indicate a failure with the network card in the specified slot. X=any card installed in slots 1,2 or 3. 975 - Unrecognizable Network Card x. Replace Network Card x. 976 - Unrecoverable software error in Network Card x. 977 - Controller software detects that a Network Card is installed in slot x but cannot establish communications with it. 978 - Bad checksum while programming Network Card x. Replace Network Card x. 979 - Flash parts failed while programming Network Card x. 980 Comm The engine is experiencing unreliable communications to the specified device. 981 The engine protocol violation detected by the specified device. Diagnostic Information 2-6