Lexmark C760 Setup Guide - Page 25
Replacing the system, board access cover, Applying the Option, Added label
View all Lexmark C760 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Replacing the system board access cover After you have finished installing cards on the printer system board, you must replace the system board access cover. 1 Align the slots at the top of the access cover with the screws near the top of the printer. 2 Slide the cover up under the top cover lip as far as it will go, and then tighten the screws at the top of the cover. 3 Insert and tighten the four screws to the bottom of the cover. If you installed a firmware card in your printer, see the following section for information about applying the Option Added label. Applying the Option Added label The Option Added label alerts service personnel that additional options have been installed in your printer. To apply the label: 1 Remove the backing from the label. 2 Place the label next to the printer model and serial number label. Install memory, firmware, or option cards 25
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
-
32
-
33
-
34
-
35
-
36
-
37
-
38
-
39