Lexmark CX827 .Users Guide PDF - Page 103
Shipping the printer, Saving energy and paper, Setting up power saver modes
View all Lexmark CX827 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
Maintaining the printer 103 CAUTION-POTENTIAL INJURY: When moving the printer, follow these guidelines to avoid personal injury or printer damage: • Make sure that all doors and trays are closed. • Turn off the printer, and then unplug the power cord from the electrical outlet. • Disconnect all cords and cables from the printer. • If the printer has separate floor-standing optional trays or output options attached to it, then disconnect them before moving the printer. • If the printer has a caster base, then carefully roll it to the new location. Use caution when passing over thresholds and breaks in flooring. • If the printer does not have a caster base but is configured with optional trays or output options, then remove the output options and lift the printer off the trays. Do not try to lift the printer and any options at the same time. • Always use the handholds on the printer to lift it. • Any cart used to move the printer must have a surface able to support the full footprint of the printer. • Any cart used to move the hardware options must have a surface able to support the dimensions of the options. • Keep the printer in an upright position. • Avoid severe jarring movements. • Make sure that your fingers are not under the printer when you set it down. • Make sure that there is adequate clearance around the printer. Note: Damage to the printer caused by improper moving is not covered by the printer warranty. Shipping the printer For shipping instructions, go to http://support.lexmark.com or contact customer support. Saving energy and paper Setting up power saver modes Eco‑Mode 1 From the home screen, touch Settings > Device > Power Management > Eco‑Mode. 2 Select a setting. Sleep mode 1 From the home screen, touch Settings > Device > Power Management > Timeouts > Sleep Mode. 2 Enter the number of minutes the printer stays idle before it enters Sleep mode. Hibernate mode 1 From the home screen, touch Settings > Device > Power Management > Timeouts > Hibernate Timeout. 2 Select the amount of time before the printer enters hibernate mode.