Lexmark E460 User Guide - Page 41
Adjusting Power Saver
View all Lexmark E460 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Minimizing your printer's environmental impact 41 Choose On (Text/Graphics) Note: This setting is best suited for printing text and line graphics. Off (Image/Photo) Note: Selecting Photo from the driver may disable Quiet Mode and provide better print quality and full speed printing. To Reduce printer noise. • Print jobs are processed at one‑half the normal processing speed. • Printer engine motors do not start until a job is ready to print. There is a short delay before the first page is printed. • Fans run at reduced speed or are turned off. • If your printer has faxing capability, fax sounds are reduced or disabled, including those made by the fax speaker and ringer. The fax is placed in standby mode. • The alarm control and cartridge alarm sounds are turned off. • The printer ignores the Advance Start command. Use factory default settings. This setting supports the performance specifications for your printer. 1 Make sure that the printer is on and Ready appears. 2 From the printer control panel, press . 3 Press the up or down arrow button until Settings appears, and then press . 4 Press the up or down arrow button until General Settings appears, and then press . 5 Press the up or down arrow button until Quiet Mode appears, and then press . 6 Press the up or down arrow button to scroll through the list of possible settings. Press Submitting Selection appears. at the correct setting. Adjusting Power Saver Available settings range from 1-240 minutes. The factory default setting is 30 minutes. To increase or decrease the number of minutes before the printer enters Power Saver mode, do one of the following: Using the Embedded Web Server 1 Type the printer IP address into the address field of your Web browser. Note: If you do not know the IP address of the printer, then print a network setup page and locate the IP address in the TCP/IP section. 2 Click Settings, and then click General Settings. 3 Click Timeouts. 4 In the Power Saver box, increase or decrease the number of minutes you want the printer to wait before it enters Power Saver mode. 5 Click Submit.