Lexmark Forms Printer 2580 User Guide - Page 40
Setting Top-Of-Form for continuous forms in pull mode
View all Lexmark Forms Printer 2580 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Loading paper 40 Setting Top‑Of‑Form for continuous forms in pull mode 1 Turn the printer on. The Paper Out light blinks if no paper is loaded. 2 Move the paper select lever down to the position. 3 Load continuous form paper on the pull tractor feed pins. 4 Open the control panel cover to access layer 2. 1 2 3 4 Power Set TOF LineFeed Macro Micro Micro Setup Pitch Lock 10 20 12 24 15 17 5 Press any paper movement button (Micro , Micro , or LineFeed) to move the paper to the Top‑Of‑Form position. Note: Use the second sheet of continuous forms paper to set Top‑Of‑Form. 6 Press Set TOF to set and save Top‑Of‑Form. 7 Close the control panel cover. Note: Top‑Of‑Form is not saved if the printer is turned off or runs out of paper when the printer is in pull tractor mode. 8 Press Start/Stop to set the printer online. Setting Top‑Of‑Form for a cut form or an envelope Top‑Of‑Form can range from minus one inch to plus 22 inches from the top of a cut form. 1 Clear the paper path. The Paper Out light blinks if no paper is loaded. If the Paper Out light is off, tear off excess forms, and then press Load/Unload. If a single form is loaded, press FormFeed to clear the paper path. 2 Move the paper select lever up to the position. 3 Load a cut sheet of paper or an envelope through the manual feeder. • If Auto Cut Sheet is set to On, the printer will move the paper or envelope to the current Top‑Of‑Form. • If Auto Cut Sheet is set to Off, press FormFeed when the Paper Out light goes off.