Lexmark Optra N model 240 Service Manual - Page 16
Operator Error Message Table, If the sensors are working properly, see - area code
View all Lexmark Optra N model 240 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
4040 Finisher Operator Error Message Table If you have a paper jam, be sure to clear all paper from the finisher, paper deck, and printer. If you are unable to clear an operator error code for a paper jam; note the location of the paper jam and check the paper sensor for that station. See "Switches" on page 4-4 or "Sensors" on page 4-5. If the sensors are working properly, see the "Service Checks" on page 2-10 for other mechanical failures. If no paper is present you must open a finisher cover to clear the error code. Message 30 Finisher Door Open (MS1, MS7) 31 Finisher Interlock Open (PI-15) 41 Paper Jam (PI-1) 42 Paper Jam (PI-2) Action Be sure the finisher top cover, right access door, and stapler access door are completely closed. If the error does not clear, check the door switches and replace if necessary. Be sure the finisher is positioned snugly against the printer and the latches on either side of the finisher are snapped in place. If the error does not clear, check the interlock sensor. Replace if necessary. There is a paper jam in the input area, right access door. If the error code does not reset after you clear the paper jam, go to the "Paper Jam, 41, Paper Input Service Check" on page 2-12. If there is still a problem after that, go to the "Symptom Table" on page 2-7. There is a paper jam at the right access door. If the error code does not clear after you clear the paper jam, go to the "Paper Jam, 42, Reversing Paper Sensor Service Check" on page 2-13. If there is still a problem after that, go to the "Symptom Table" on page 2-7. 2-3