Lexmark Optra T616 Technical Reference - Page 237
InputAttributes, Definition, Offset s is set to Between Jobs.
View all Lexmark Optra T616 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 237 highlights
4-69 PostScript Table 4-16: Page Device Parameters (Continued) Key InputAttributes (continued) Type dictionary Definition Mode is a key within the InputAttributes dictionary, and its value is a name that determines the mapping of the physical input sources to the input sources listed in InputAttributes. The allowable values are: /Default Printer's default source assignment /Optra Specifies the following ordering used in InputAttributes: 0 - Tray 1 1 - Tray 2 2 - Envelope Feeder 1 or Multipurpose feeder 3 - Tray 3 4 - Multipurpose feeder 5 - Tray 4 6 - Tray 5 7 - Feeder 2 /HPLJFamily1 Specifies the following ordering used by the HewlettPackard Company's printers: 0 - Tray 1 1 - Tray 2 2 - Envelope Feeder 1 or Multipurpose feeder 3 - Multipurpose feeder (see Note) 4 - Tray 3 5 - Tray 4 6 - Tray 5 7 - Feeder 2 Install Jog procedure integer Note: Values 3 and 4 for the Hewlett Packard Company's LaserJet printers are switched relative to the /Optra values 3 and 4. Priority is an array of integers that describes the order in which the input sources are searched. The first integer represents the highest priority source and so on. If no array exists or none of the matching sources is in the array, then the priority order is arbitrary. Installs device dependent parameters into the graphics state. This procedure can modify any parameter in the graphics state. Specifies which Offset Pages setting is used. The following values are supported: 0 Offset Pages is disabled. 1 Offset Pages is disabled. 2 Offset Pages is set to Between Jobs. 3 Offset Pages is set to Between Copies. Offset refers to stacking entire print jobs or copies of the same print job in two separate groups in an output bin.