Lexmark W812 Technical Reference - Page 349
Table 8-1, Parallel Connector Pin Assignments Continued, Honor Init
View all Lexmark W812 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 349 highlights
8-11 Interfaces Table 8-1: Parallel Connector Pin Assignments (Continued) Pin IEEE 1284-B Connector IEEE 1284-C Connector 14 15-17 18 N/A 19-30 17 N/A N/A 18 19-35 Signal Direction AUTO FEED XT* In Inverted logic: signal is active when low. LOGIC GROUND VCC HOST LOGIC In HIGH GND Return 31 14 INIT* In signal is active when low 32 4 ERROR* Out Inverted logic: signal is active when low 33-35 N/A LOGIC GROUND N/A means non-applicable. Description Host Busy when Advanced Status is On. Logic Ground 300 mA of 5 V +/ - 5% Driven by the host. These pins are grounded signals used as twisted pairs with the data and control signals. GND is often called a logic ground, and a fusible link isolates it from chassis ground to offset any large ground shifts when the printer and computer are on different circuits. The rising edge of a negative pulse on this line causes the printer to initialize. The printer synchronizes this function with the received data. On the falling edge of INIT*, the printer drives the BUSY interface signal active. On the rising edge of INIT*, the printer: • Prints all received data • Displays RESET • Initializes • Deactivates the BUSY signal To disable INIT* processing, set Honor Init to Off from the printer operator panel or through MarkVision Professional. Refer to your printer user documentation for more information. This signal indicates a printer error condition. The signal level becomes low when the printer is: • In paper exception status • Not ready because of an operator panel command to stop • Not ready because of a software command to stop • Not ready because of a software command for manual feed This signal is activated approximately 5 seconds after one of the above conditions sets BUSY. Not used.