Lexmark Wheelwriter 10 Operation Guide - Page 37
Installing, Printwheel, Batteries
UPC - 587609051690
View all Lexmark Wheelwriter 10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Installing the Printwheel Important: Remove the yellow shipping seal from the center of a new printwheel before you install it. iBM Logo Misses this mat. When me *amis. Moses varsenius ebRistbsta. Itsitirss loft procinick Remove This Shipping Seal CAUTION To prevent unwanted carrier motion, make sure the paper ball is against the platen. 1. Hold the printwheel so the letters IBM are in the upper left corner. 2. Pull the print hammer all the way toward you and hold it. 3. While you are holding the print hammer, lower the printwheel into the slot. Be careful not to scratch the ribbon. 4. Alter the printwheel touches the bottom of the slot, release the print hammer. 5. Press the Code key: • The printwheel spins. Paper Bali Tab Batteries Your typewriter uses three size AA alkaline batteries. These batteries are used to save margins, tabs and other settings when the typewriter is turned off. They must be installed correctly and changed at least once every year (before they run down). When changing the batteries, use only size AA alkaline batteries (for example,' Duracell' type MN.1500, Evereadr type E91, Ray-O-Vac4 type 815, or equivalent). Do not use rechargeable batteries. Checking the Batteries If the beeper signals three times and the Line Space lights blink continuously when you turn the typewriter on, check the following while the typewriter is on: 1. Look at the batteries for correct installation. 2. If the batteries are installed correctly, the batteries may be weak or dead. 3. Replace all three weak or dead batteries. 4. Do not turn the typewriter off while replacing the old batteries. If you turn the typewriter off without batteries installed, margins and other settings will be lost. (See page 4-13 for correct installation.) Notes: The Line Space lights blink alternately indicating the battery is low, but you have not lost your settings. 2. The Line Space lights blink continuously indicating you have lost your settings. „ pop 4-10 Operator's Guide Print Hammer 2 Trademark of Duracell. Inc. 5 Trademark of the Union Carbide Corp. 4 Trademark of the Ray-O-Vac Corp, Reference 4.11