Lexmark X3350 Setup Sheet - Page 1

See the troubleshooting guide on the reverse of this sheet. *23A0170* 3300 Series All-In-One Unpack your All-In-One. 1 Note: Contents may vary based on geography. Your All-In-One may include a photo cartridge instead of a black print cartridge. Connect the power cord to the power supply. 2 www.lexmark.com Make sure the power light is on. 3 Before you continue, remove the photo cartridge from the print cartridge storage unit. Note: You may need to purchase a USB cable separately. Note: Save the print cartridge storage unit to protect any open cartridges not in use. 4 Press to scroll to your language and then press . Lift the paper support and extend 5 the paper exit tray. 2 1 6 1 Pull back the transparent deflector. 2 Load the paper flat and to the right. 3 Squeeze the paper guide. Slide it to the right until it is snug. 2 3 1 Lift the scanner unit. 7 Remove the sticker and tape 8 from the print cartridges. 1 2 1 2 9 1 Open the cartridge lids by pressing the front tabs. 2 Insert the cartridges and push them down firmly. 3 Snap the lids tight. Left: photo or black Right: color only 1 2 3 Close the scanner unit. 10 2 1 3 11 Press to print an alignment page. Safety information CAUTION: Do not set up this product or make any electrical or cabling connections, such as the power supply cord or telephone, during a lightning storm. • Use only the power supply provided with this product or the manufacturer's authorized replacement power supply. • Connect the power supply cord to an electrical outlet that is near the product and easily accessible. • Refer service or repairs, other than those described in the user documentation, to a professional service person. You may discard the page after it prints. Steps 12-15