Lexmark XM9155 User's Guide - Page 140

Understanding the printer menus 140 Use Baud 1200 2400 4800 9600 19200 38400 57600 115200 138200 172800 230400 345600 Data Bits 7 8 Parity Even Odd None Ignore Honor DSR On Off To Specify the rate at which data can be received through the serial port. Notes: • 9600 is the factory default setting. • 138200, 172800, 230400, and 345600 baud rates are only displayed in the Standard Serial menu. These settings do not appear in the Serial Option 1, Serial Option 2, or Serial Option 3 menus. Specify the number of data bits sent in each transmission frame. Note: 8 is the factory default setting. Set the parity for serial input and output data frames. Note: None is the factory default setting. Determine whether the printer uses the DSR Signal. Notes: • Off is the factory default setting. • DSR is a handshaking signal used by most serial cables. The serial port uses DSR to distinguish data sent by the computer from data created by electrical noise in the serial cable. The electrical noise can cause stray characters to print. Set this to On to prevent stray characters from printing. SMTP Setup menu Use Primary SMTP Gateway Primary SMTP Gateway Port Secondary SMTP Gateway Secondary SMTP Gateway Port SMTP Timeout 5-30 Reply Address To Specify SMTP server gateway and port information. Note: 25 is the default SMTP gateway port. Specify the amount of time in seconds before the server stops trying to send an e‑mail. Note: 30 seconds is the factory default setting. Specify a reply address of up to 128 characters in the e-mail sent by the printer.