LiftMaster 8160 8160 Users Guide Manual - Page 7

Operation Programming - Multi-Function Control Panel Service LED LEARN Button LOCK Button Command LED LIGHT Button Features Lock Light To Program a Remote Control or Keyless Entry Maintenance Alert System (MAS) NOTE: Your remote controls will NOT work when LOCK mode is active however your keyless entry will still allow access to your garage. Activate: Press and hold the LOCK button for 2 seconds. The command LED will flash as long as the lock feature is activated and your handheld remote control will not operate your door at this time. Deactivate: Press and hold the LOCK button again for 2 seconds. The command LED will stop flashing and normal operation will resume. To change the amount of time the garage door opener lights will stay on (default time is 4-1/2 Minutes): Press and hold the LOCK button until the garage door opener lights flash.* The garage door opener lights will then indicate the current light duration by flashing up to 4 times (see table below). NUMBER OF TIMES GARAGE DOOR OPENER LIGHTS FLASH 1 2 3 4 TIME THE GARAGE DOOR OPENER LIGHT STAYS ON 1½ Minutes 2½ Minutes 3½ Minutes 4½ Minutes To change the light duration time repeat the steps above until the lights flashes indicate your desired time frame. NOTE: Factory setting is on. This feature will turn on the garage door opener lights when the safety reversing sensors beam has been broken. Deactivate: Start with the garage door opener lights off. Press and hold the LIGHT button to turn on the light, continue to hold until the light turns off.* Activate: Start with the garage door opener lights on. Press and hold the LIGHT button to turn off the light, continue to hold until the light turns on.* * Approximately 10 seconds 1. Press the LEARN button on the door control twice. The Command LED will blink. 2. Remote Control: Press and release the button on the remote control that you wish to operate your garage door. Keyless Entry: Enter a 4-digit personal identification number (PIN) on the keypad. Then press the ENTER button. The garage door opener lights will flash (or two clicks will be heard) and the Command LED will stop blinking when the code has been programmed. Activate/Deactivate NOTE: Factory setting is on. Press and hold the LEARN button. Then press the LIGHT button. The service LED will flash the status; Activated is 2 flashes and deactivated is 3 flashes. 7