LiftMaster 8160WB Owners Manual - Page 15
Install the Light Bulbs for Models 8160W, 8160WB, Install the Light Bulbs for Models 8155W, 8164W
View all LiftMaster 8160WB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Installation 6 Install the Light Bulbs for Models 8160W, 8160WB Install the Light Bulbs for Models 8155W, 8164W and 8165W To prevent possible OVERHEATING of the end panel or light socket: l Use ONLY A19 incandescent (100W maximum) or compact fluorescent (26W maximum) light bulbs. l DO NOT use incandescent bulbs larger than 100W. l DO NOT use compact fluorescent light bulbs larger than 26W (100W equivalent). l DO NOT use halogen bulbs. l DO NOT use short neck or specialty light bulbs. 1. Pull on the top center of the light lens and rotate the light lens down. 2. Insert an A19 incandescent (100W maximum) or compact fluorescent (26W, 100W equivalent) light bulb into the light socket. NOTE: DO NOT use halogen, short neck, or specialty light bulbs as these may overheat the end panel or light socket. DO NOT use LED bulbs as they may reduce the range or performance of your remote control(s). 3. Rotate the lens up to close. or To prevent possible OVERHEATING of the end panel or light socket: l Use ONLY A19 incandescent (100W maximum) or compact fluorescent (26W maximum) light bulbs. l DO NOT use incandescent bulbs larger than 100W. l DO NOT use compact fluorescent light bulbs larger than 26W (100W equivalent). l DO NOT use halogen bulbs. l DO NOT use short neck or specialty light bulbs. 1. Press the release tabs on both sides of lens. Gently rotate lens back and downward until the lens hinge is in the fully open position. Do not remove the lens. 2. Install a 100 watt maximum light bulb in each socket. Light bulb size should be A19, standard neck only. The lights will turn ON and remain lit for approximately 4-1/2 minutes when power is connected. Then the lights will turn OFF. 3. Reverse the procedure to close the lens. NOTE: If the bulbs burn out prematurely due to vibration, replace with A19, standard neck garage door opener bulbs. The use of short neck or specialty light bulbs may overheat the endpanel or light socket. 100 Watt (Max) Standard Light Bulb Release Tab Lens Hinge 15