LiftMaster 8160WB Owners Manual - Page 20
Install the Door Control - 883LMW, Install the Door Control
View all LiftMaster 8160WB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Install the Door Control 1 Install the Door Control - 883LMW To prevent possible SERIOUS INJURY or DEATH from electrocution: l Be sure power is NOT connected BEFORE installing door control. l Connect door control ONLY to 12 VOLT low voltage wires. To prevent possible SERIOUS INJURY or DEATH from a closing garage door: l Install door control within sight of garage door, out of reach of small children at a minimum height of 5 feet (1.5 m) above floors, landings, steps or any other adjacent walking surface, and away from ALL moving parts of door. l NEVER permit children to operate or play with door control push buttons or remote control transmitters. l Activate door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel. l ALWAYS keep garage door in sight until completely closed. NEVER permit anyone to cross path of closing garage door. INTRODUCTION Compatible with myQ® and Security+ 2.0® accessories, see page 45. Your garage door opener is compatible with up to 2 Smart Control Panels or 4 of any other Security+ 2.0® door controls. NOTE: Older LiftMaster door controls and third party products are not compatible. Install door control within sight of garage door, out of reach of small children at a minimum height of 5 feet (1.5 m) above floors, landings, steps or any other adjacent walking surface, and away from ALL moving parts of door. For gang box installations it is not necessary to drill holes or install the drywall anchors. Use the existing holes in the gang box. NOTE: Your product may look different than the illustrations. HARDWARE 1. Strip 1/4" (6 mm) of insulation from one end of the wire and separate the wires. 2. Connect one wire to each of the two screws on the back of the door control. The wires can be connected to either screw. 3. Mount the door control with the hardware provided. 1 2 3 1/4" (6 mm) Screw 6ABx1" (2) 20