LiftMaster 8165 Contractor Series User's Guide Manual - Page 6

Operation Programming - Multi-Function Control Panel Features Service LED Command LED Lock Light NOTE: Your remote controls will NOT work when LOCK mode is active however your keyless entry will still allow access to your garage. Activate: Press and hold the LOCK button for 2 seconds. The command LED will flash as long as the lock feature is activated and your handheld remote control will not operate your door at this time. Deactivate: Press and hold the LOCK button again for 2 seconds. The command LED will stop flashing and normal operation will resume. To change the amount of time the garage door opener lights will stay on (default time is 4-1/2 Minutes): Press and hold the LOCK button until the garage door opener lights flash.* The garage door opener lights will then indicate the current light duration by flashing up to 4 times (see table below). NUMBER OF TIMES GARAGE DOOR OPENER LIGHTS FLASH 1 2 3 4 LEARN Button LOCK Button LIGHT Button TIME THE GARAGE DOOR OPENER LIGHT STAYS ON 1 ½ Minutes 2 ½ Minutes 3 ½ Minutes 4 ½ Minutes To change the light duration time repeat the steps above until the lights flashes indicate your desired time frame. NOTE: Factory setting is on. This feature will turn on the garage door opener lights when the safety reversing sensors beam has been broken. Deactivate: Start with the garage door opener lights off. Press and hold the LIGHT button to turn on the light, continue to hold until the light turns off.* Activate: Start with the garage door opener lights on. Press and hold the LIGHT button to turn off the light, continue to hold until the light turns on.* * Approximately 10 seconds To Program a Remote Control or Keyless Entry 1. Press the LEARN button on the door control to enter Programming Mode. 2. Press the LEARN button again, the LED will flash once. 3. Remote Control: Press the button on the remote control that you wish to operate your garage door. Keyless Entry: Enter a 4-digit personal identification number (PIN) of your choice on the keyless entry keypad. Then press the ENTER button. The garage door opener lights will flash (or two clicks will be heard) when the code has been programmed. If programming is unsuccessful, repeat steps 1-3 or program the remote using the learn button on the garage door opener. Maintenance Alert System (MAS) Activate/Deactivate NOTE: Factory setting is off. Press and hold the LEARN button. Then press the LIGHT button. The service LED will flash the status; Activated is 2 flashes and deactivated is 3 flashes. 6