LiftMaster 8355W 8355W Installation Manual - Page 33

Operation Remote Control Your remote control has been programmed at the factory to operate with your garage door opener. Up to 24 Security+ 2.0® remote controls can be programmed to the garage door opener. Older LiftMaster remote controls are NOT compatible, see page 38 for compatible accessories. To program additional accessories refer to the instructions provided with the accessory or visit LiftMaster.com. If your vehicle is equipped with a Homelink®, you may require an external adapter depending on the make, model, and year of your vehicle. Visit www.homelink.com for additional information. TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN USING THE DOOR CONTROL 1. Press the LEARN button on the door control twice. The Command LED will blink. 2. Remote Control: Press and release the button on the remote control that you wish to operate your garage door. Keyless Entry: Enter a 4-digit personal identification number (PIN) on the keypad. Then press the ENTER button. The garage door opener lights will flash (or two clicks will be heard) and the Command LED will stop blinking when the code has been programmed. Repeat the steps above for programming additional remote controls or keyless entry devices. If programming is unsuccessful, program the remote using the learn button. 1 LEARN button Command LED PROGRAM USING THE LEARN BUTTON ON THE GARAGE DOOR OPENER 1. Press and release the LEARN Button on the garage door opener. 2. Press and hold the button on the remote control that you wish to use. Release the button when the garage door opener lights blink or two clicks are heard. 1 2 "cli"cckl"ick" LEARN Button LEARN LED To Erase the Memory ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES 1. Press and hold the LEARN button on garage door opener until the learn LED goes out (approximately 6 seconds). All remote control and keyless entry codes are now erased. Reprogram any accessory you wish to use. ERASE ALL DEVICES (Including MyQ® enabled accessories) 1. Press and hold the LEARN button on garage door opener until the learn LED goes out (approximately 6 seconds). 2. Immediately press and hold the LEARN button again until the learn LED goes out. All codes are now erased. Reprogram any accessory you wish to use. ERASE THE Wi-Fi NETWORK FROM THE GARAGE DOOR OPENER 1. Press and hold the black adjustment button on the garage door opener until 3 beeps are heard (Approximately 6 seconds). ERASE A MyQ® ACCOUNT Go to myLiftMaster.com to delete your MyQ account. 2 OR 4GHI 5 6 JKL MNO 7 8 9 PRS TUV WXY * * 0 QZ # 0 QZ # ENTER ENTER LEARN Button ???? PIN Black Adjustment Button 33